WINC1500 PICTAIL
TM
/PICTAIL
PLUS DAUGHTER BOARD
USER’S GUIDE
2017 Microchip Technology Inc.
Advance Information
DS70005309A-Page 15
Chapter 2. Hardware
This chapter describes the hardware features of the WINC1500 PICtail/PICtail Plus
Daughter Board.
2.1
HEADERS AND CONNECTORS
This section provides the details of each component on the WINC1500 PICtail/PICtail
Plus Daughter Board. For the location of these components, see
.
2.1.1
PICtail Plus Connector (J2)
The WINC1500 PICtail/PICtail Plus Daughter Board has a 30-pin card edge connector
to interface with 16-bit and 32-bit development board’s PICtail Plus connector, refer to
2.1.2
PICtail Connector (J5)
The WINC1500 PICtail/PICtail Plus Daughter Board has a 28-pin right angle connector
to interface with the 8-bit development board’s PICtail Plus connector.
provides the pinout details of the PICtail/PICtail Plus connectors.
TABLE 2-1:
PICTAIL/PICTAIL PLUS CONNECTOR PINOUT
Pin on PICtail
Plus 30-pin
connector (J2)
Pin on PICtail
28-pin
connector (J5)
Pin on
ATWINC1510-MR210PB
Function
28
25
4
ATWINC1500 RESET
14
11
11
ATWINC1500 WAKE
18
27
13
ATWINC1500 IRQ
30
23
22
ATWINC1500 CHIP ENABLE
1
24
16
SPI_SS
7
8
15
SPI_MOSI
5
10
17
SPI_MISO
3
12
18
SPI_SCK
9,10,15,16
28
9,12, 28
GND
22
26
20, 23
(1)
V
CC
Note 1:
The V
CC
of the base board is connected to the V
CC
of the module through a power
selection connector when jumper is placed on the 1-2 of the header (J8).