Microframe Corporation
10
604 South 12
th
Street
Broken Arrow, OK 74012
800-635-3811
www.microframecorp.com
Series 3500
Programming the Pagers
To begin using your paging system, you will first need to
program the pagers. To do this, place all pagers in the
charging base securely. Press and hold the “PROG” button
until it beeps (about 10 seconds). The base will show “WRT”,
and the pagers will flash multiple values. It has now
programmed the pager settings to match the base station.
Sending a Page
Please see the diagram in the MultiPage section of this
manual for detailed instructions on sending pages.
Sending a Group Page
All pagers respond to call number “1244”. To page all pagers,
simply enter “1244” and “SEND”. Then, press “SEND” again
at the beep type prompt.
Renumbering the Pagers
Place pagers securely in the base station. Press and hold the
“UP” button until it beeps (about 3 seconds). The pagers will
be programmed to the associated slot number. See photo on
right.
Changing the Alert Mode
Pagers may be programmed to respond to a page by a
combination of vibrating, flashing and beeping. By default the
pagers are programmed to flash and vibrate for 2 minutes.
See below to set a new alert mode.
Out of Range
These pagers can be programmed to alert continuously once
they get out of range of the transmitter. To use this feature,
first activate the option on the transmitter (see MultiPage
Transmitter, Option 7
– Out of Range), then set option “9494”
(below).
Setting Pager Options
Unplug the charging base or remove all pagers from the
base. [Pagers cannot receive programming changes when
they are charging.] Wait for the demo page to stop (about 7
seconds). Press “1248” followed by “SEND”, then “ENTER”.
Enter the desired option (see below), then press
“SEND”. For
example, if you want the pagers to flash only, press “1248-
SEND-ENTER-9797-
SEND”. After sending the code, all the
pagers should light up to indicate the programming was
received. Plug in the charging base or return all pagers to the
base.
Vibrate Only
“9292”
Out of Range Off
“9393”
Out of Range On
“9494”
Flash & Beep
“9595”
Flash & Vibrate
“9696”
Flash Only
“9797”
Beep, Flash, & Vibrate
“9898”
