LIVE575
2
Please read this manual carefully before use.
Technical Specifications
Voltage: 120v 60Hz
Lamp: HMI575W
Control signal: DMX512 international standard signal
Number of channels: 4
Packing size: projector: 105.5
×
46
×
32(cm)
Control bar:39.5
×
32.5
×
23.5(cm)
Weight:40KG
Functions
z
IP20 protection.
z
Quick, accurate, stable and noiseless colour switching system.
z
Overheat protection and high voltage line protection.
z
15 degree beam angle with a projection distance of 40m.
z
Manual focus
z
Electronically adjustable iris.
z
0 – 100% linear dimmable
z
6,000k, 5,600k and 3,200k colour temperature selector
z
Two high-powered fans for cooling system, optimized internal air duct design.
z
Adjustable strobe effect (0-7 flashes per second).
z
2 colour wheel, able to create up to 20 color combination.
z
Rainbow effects
z
DMX 512 controllable – 4 channels
Installation Tips
z
Safety inspection:
after unpacking the unit, please inspect the unit for any damage that may have occurred
during shipping. If any damage is seen, please report this to your dealer immediately.
z
Installation and removal of lamps:
make sure the power is disconnected and the lamp is cooled before
attempting to remove the lamp. In order to remove the lamp, carefully unscrew the two finger nuts located
on either side of the lamp. Remove defective lamp and install new lamp making sure not to touch glass
portion of the lamp with bare hands as the residue from left from touching the lamp will potentially shorten the
life of the lamp. If for any reason you accidentally touched the lamp, lightly moisten a lint free soft fabric
with rubbing alcohol and gently clean the area. Please ensure that the notch located on the round part of the
lamp is facing upwards. Once the lamp is in position, firmly tighten finger screws.
z
Formula for addressing DMX code setting :
This unit is capable of being controlled via DMX 512. The
unit uses 4 DMX channels to control colour, iris, dimmer and strobe effects. The address settings will be
determined by the DMX controller in use together with the position of the fixture in the DMX chain. Use the
dip switches found on the back of the unit to set the DMX address once you have calculated the DMX address
needed.
