© Microhard Systems Inc.
134
4.0 Configuration
TCP Mode Status
Disable or enable the Modbus TCP Connection Service on the IPn4G.
Values (selection)
Disable
Enable
Port
Specify the Port in which the Modbus TCP service is to listen and respond
to polls.
Values (Port #)
502
Active Timeout(s)
Define the active timeout in seconds.
Values (seconds)
30
Slave ID
Each Modbus slave device must have a unique address, or Slave ID. Enter
this value here as required by the Modbus Host System.
Values (value)
1
Coils Address Offset
Enter the Coils Address offset as required by the Master.
Values (value)
0
Input Address Offset
Enter the Input Address offset as required by the Master.
Values (value)
0
Register Address Offset
Enter the Register Address offset as required by the Master.
Values (value)
0
Master IP Filter Set
It is possible to only accept connections from specific Modbus Master IP’s,
to use this feature enable the Master IP Filter and specify the IP Addresses
in the fields provided.
Values (selection)
Disable /
Enable
