Fig 18
Inside
Cut
1
Outside Cut
6
16
HOW TO USE
Resawing: You can resaw narrow stock in one pass without a bandsaw, planer
or flat-bed sander.
CAUTION! Stock must be square before resawing.
Resawing stock thinner than 1/4”, or resawing wider
stock, can be achieved in two passes by setting the
saw blade slightly higher than one half of the width
of the stock in the first pass . Flip the stock over and
finish with a second cut .
Suggestion: Resawing stock thinner than 1/4”
should be obtained from the outside cut .
A wooden spacer can be added to the Balance
Support (6) for stock wider than 2”
(see Figure 3 on
Page 5) .
INFO:
Watch the online video to see this
and many other techniques: microjig .com/worksafer
Resaw to 1/4” (Inside Cut) or thicker in one pass as shown in
Figure 18 .
Note Handle (1) location .
Figure 18
With one of the Side Legs removed, the
Center Leg (3) is registered against the
rip fence, and the Stabilizing Plate (7) of
a GR-200 holds the dowel against the rip
fence . You can also split a round dowel in
half .
INFO:
Watch the online video:
microjig .com/dowel
RESAWING
GROOVING A ROUND DOWEL
Fig 19
Center Leg (3) is secured
against rip fence when
feeding the dowel .
Dowel
3
Stabilizing Plate (7)
against the dowel .
Figure 19