OPERATION PRECAUTIONS & SAFETY
6
SAFETY WARNING!
Operation of the GRR-RIPPER 3D Pushblock system
includes the use of a table saw or other tools that are not part of the GRR-RIPPER.
Micro Jig, Inc. assumes no liability for any product not sold and manufactured by Micro
Jig, Inc. You must take all necessary precautions when operating a table saw or other
tools as recommended by their manufacturers or as required by any prudent tool user.
You must also read and agree to the safety precautions and terms listed below before
using the GRR-RIPPER 3D Pushblock system. Your assembly of the GRR-RIPPER 3D
Pushblock system indicates your agreement to follow these safety precautions and
terms when using this tool.
The following operation precautions of using the GRR-Ripper on table saw
are based on the rip fence is installed to the right of saw blade.
The GRR-RIPPER 3D Pushblock System
includes three legs with non-slip pads .
A minimum of two legs MUST be
installed during any cutting operation .
Use at least one leg to the right and
one leg to the left of the saw blade
whenever possible .
Before every cut, you must look
through from the end of the tool after
it is in an operational position to make
sure the cutter will go through the
tunnel between the legs throughout the
cutting operation without touching any
component of the tool or other objects
except the workpiece .
The bottom of the workpiece must be
flat enough so that it does not rock on
the table top . The top of the workpiece
must be flat enough so all non-slip
surfaces are in full contact with the top
surface of the workpiece .
In table saw operation, the face of the
Side Leg on the right must be in full
contact with the rip fence at all times
in order to create a parallel guide for
forward feeding and inward pressure
against the rip fence .
The saw blade must not be set more
than 3/4” higher than the top surface
of a flat workpiece . The ideal height is
when the top gullet is slightly above the
top surface of the workpiece .
BEFORE USE
