5
BC 300 Maxi 2 in 1
EN
Make sure that the temperature of the liquid in the bottle never
exceeds 50 °C.
Ensure that children do not use this device unsupervised;
some parts are small enough to be swallowed. Be aware of
the risk of strangulation in case this device is supplied with
cables or tubes.
IMPORTANT
When transporting breast milk in the bottle (e.g. when on
the move or travelling), make sure that the bottle cap is
always screwed on tightly.
WARNING
Notes on handling batteries
If your skin or eyes come into contact with battery fluid, rinse the
affected areas with water and seek medical assistance.
Choking hazard! Small children may swallow and choke on
batteries. Store the batteries out of the reach of small children.
Observe the plus (+) and minus (-) polarity signs.
If a battery has leaked, put on protective gloves and clean the
battery compartment with a dry cloth.
Protect batteries from excessive heat.
Risk of explosion! Never throw batteries into a fire.
Do not charge or short-circuit batteries.
Use identical or equivalent battery types only.
Always replace all batteries at the same time.
Do not use rechargeable batteries.
Do not disassemble, split or crush the batteries.
Remove batteries if the device is not going to be used for a
prolonged period.
Disposal
Batteries and electronic devices must be disposed of in
accordance with the locally applicable regulations, not with
domestic waste.
3. Using the Device for the First Time
NOTE:
Check that the packaging of the device has not been
tampered with and make sure that all components are
present. Before use, ensure that there is no visible damage
to the device or accessories and that all packaging material
has been removed. If you have any doubts, do not use the
device and contact your retailer or the specified Customer
Services address.
Assembling the device
Once the device has been removed from the packaging, check the
plastic containers in particular for cracks.
1. Screw the pump attachment
AT
onto the bottle
AL
. Ensure the
pump attachment is firmly secured so that no liquid can escape
(see short instruction).
2. Insert the silicone tube for dual pump mode
7
into the 2 pump
attachments
AT
and the device
1
.
3. For one-sided pumping, insert the silicone tube for one-sided
pumping into the device
1
and the pump attachment
AT
.
4. Connect the device to the mains cable and insert the mains plug
into the socket.
5. If you choose to operate the device using batteries, open the
battery compartment cover on the rear side of the motor unit.
Insert the batteries (4 x 1.5 V, size AA), observing the indicated
polarity. Close the battery compartment until you hear and feel
it click into place. A single battery charge with 4 x 1.5 V new AA
batteries will last for approximately 60 minutes of operation (at
the lowest setting).
Cleaning and sterilising the device
WARNING
Clean and sterilise the separate parts of the device that
come into direct contact with the breast milk individually
before first use and any further use.
To sterilise the device correctly, proceed as follows:
1. Unscrew the pump attachment
AT
from the bottle
AL
.
2. Remove the silicone tube
7
from the pump attachment
AT
and
from the device.
3. Separate the pump attachment from silicone membrane and
silicone valve.
4. Sterilise the bottles and pump attachment (with silicone
membrane and silicone valve) for five minutes in boiling water
or using a steam steriliser. Do not use the device until all indi-
vidual parts are completely dry. Do not use any antibacterial
cleaning products, since these may damage the plastic on the
device.
5. Clean the device carefully using a slightly damp cloth only. Do
not use any cleaning agents or solvents. Under no circum-
Summary of Contents for BC300 Maxi 2 in 1
Page 9: ...9 BC 300 Maxi 2 in 1 EN ...
Page 73: ...73 BC 300 Maxi 2 in 1 TR ...
Page 81: ...81 BC 300 Maxi 2 in 1 AR ...
Page 89: ...89 BC 300 Maxi 2 in 1 FA ...
