Installation guide
– Assemble the bracket as shown on the picture;
– Attach the illuminator with a visor to the bracket using two internal hexagon screws M4x10 (included in your package). Adjust
horizontal placement settings;
– Vertically fix the bracket with the illuminator, losing the hinge screw adjust rotation and vertical angles, tighten the screw;
– Connect to a power source;
Connection polarity is not necessary.
– Remove plastic film from the glass
– Unscrew the plastic lid from the back panel of the illuminator. Rotating the adjusting screw, set the desired illumination
angle ;
If you use electric instrument, to avoid breakage of the adjustment mechanism, the torque applied to adjustment
screw should not exceed 0.1 Nm
;
– Screw the plastic lid back in.
The Manufacturer establishes the minimum angle of radiation equal 2˚. One turn of the adjusting screw changes a
radiation angle on 1.3˚.
1
2
3
