3 Sample Files
C
REATE
S
AMPLE
F
ILES
Options > Option Presentation > Show Degas Conditions
File > New Sample > [.SMP File]
File > Open > [.SMP File]
For 21CFR11 environments, this section is applicable only to members of the
Developer group; however, members of the Analyst group may find information in this
section helpful. Sample file information that is available to Analysts is created by a
member in the Developer group using information in this section.
Each analysis must be linked with a sample file before the analysis can proceed. A sample file can
consist of parameter files; however, parameter files can also stand alone.
Specify or change the option presentation by selecting
Options > Option Presentation,
or use
the view selector drop-down list at the bottom of the window.
Sample files created in the
Basic
option presentation must be selected from parameter files
created in the
Advanced
option presentation. The values specified in the parameter portions of the
default method are the defaults for new sample files. To navigate from one set of parameters to
another, select the parameter tab across the top of the window.
The
Degas Conditions
tab displays only if enabled in
Options > Option
Presentation > Show Degas Conditions
Advanced or Developer view
Basic or Analyst view
3 - 2
Gemini VII Operator Manual
239-42828-01 (Rev H ) — May 2021
Summary of Contents for GEMINI VII
