For North American fuse arrangement:
1. Remove the fuse block:
a. Open the cover to the right of the power entrance by inserting a small screwdriver in the
left side of the power module, then gently pry the cover open.
b. Loosen the Phillips screw two turns.
c. Remove the fuse block by sliding it up, then away from the Phillips screw and lifting the
block from the pedestal.
A. Fuse cover
B. Fuse block
C. Jumper
D. Fuse
2. Insert the fuse.
3. Set the voltage. See
Select the Voltage on the next page
then continue with these steps.
4. Slide the block back onto the Phillips screw and pedestal.
5. Tighten the Phillips screw and replace the cover.
Select Input Power
VacPrep Operator Manual
061-42802-01 (Rev B) — Apr 2021
2 - 7
