Long Gage Strain Sensor |
os3610
C o p y r i g h t © 2 0 1 2 M i c r o n O p t i c s , I n c .
o s 3 6 1 0 I n s t a l l a t i o n G u i d e , R e v i s i o n A
8
interior of the foam insulator. The insulation is designed so that the fiber can be spliced and
excess fiber coiled and stored above the sensor.
Figure 11
– EPS Frame
Plan ahead and determine where the fiber will enter and exit the stainless steel cover shown in
Figure 13. The foam insulation can be cut with a knife as needed to provide fiber access. The
EPS foam insulation can be attached to a variety of surface materials using a silicone sealant
(such as 3M Super Silicone Sealant, Part No. 08663), or other compatible adhesive. Complete
the insulation assembly by attaching the EPS foam cover to the base using silicone sealant or
other compatible adhesive. The completed foam insulation is shown in Figure 12.
Figure 12
– EPS Lid
