5. repeat steps 1 to 3 to revert to the Inertia knob controlling throttle inertia.
•
If the Inertia knob is being used for Inertia or channel 4, the Bind button controls channel 5 if pressed for less than 20s
•
If the Inertia knob is being used for channel 5, the Bind button has no effect on channel 5 but is still used for binding
and toggling what the Inertia pot is used for.
Receiver Programming with Tx22v2
Deltang receivers may be programmed using Tx22v2. The receivers have a rich set of functionality which is not possible to
describe here, refer to the Deltang web site at
for details on programming sequences for a specific receiver.
Please contact Micron if this table looks too daunting and we will send you specific programming instructions for the function
you want to change.
The receiver must first be put into programming mode and then the Tx22v2 toggle switch is used to enter a programming
sequence. There are 2 methods of getting a receiver into programming mode:
1. place the controls for R/C channels 2 and 4 at the extreme positions and then switch receiver on, or
2. switch receiver on and enter the morse code SOS using the bind button (R/C channel 5)
Method 1 works for all Deltang receivers, method 2 works only for Rx6 types and Rx47.
Method 1 (chan 2 and 4)
1. switch Tx22v2 on, receiver off
2. set the Inertia knob to control channel 4 (described above).
3. rotate the channel 2 (Selecta) and channel 4 (Inertia) knobs fully left or right (not centred).
4. centre the channel 3 (Direction) toggle switch.
5. put channel 1 (Throttle) in the 'off' position.
6. switch the receiver on
.
7. the receiver LED will flash rapidly
8. centre the Selecta and Inertia knobs
9. the receiver LED will flash once, pause and repeat
Method 2 (SOS)
1. switch the Tx22v2 on and then the receiver, receiver LED must be lit
2. centre the toggle switch
3. wait at least 5 seconds without touching any transmitter control
4. tap out the morse SOS (... --- …) on the bind button where:
◦
a dot is a short press of less than 0.7 second
◦
a dash is a long press of about 2 seconds
◦
pauses between dots or dashes is about 1 second
5. if the SOS is accepted, the receiver LED will flash once, pause and repeat
6. if the SOS was not accepted go back to step 3
To enter a receiver program sequence
The Tx22v2 toggle switch is used to enter the value for each level of the sequence, the receiver LED flashes to show the digit
value. For example, the sequence to set Rx60 output P3 to on/off latching and operated by the bind button is 3 3 2 5 1.
Decoding this sequence gives:
Level Value Explanation
1
3
Programming table menu 3
2
3
Rx60 output P3
3
2
on/off latching
4
5
channel 5 = bind button
Tx22v2 User Information
3 of 4
info@micronradiocontrol.co.uk
