Installation
As with any electric device, you should place the equipment where it will not be subjected to
extreme temperatures, humidity, or electromagnetic interference. Specifically, the site you
select should meet the following requirements:
The ambient temperature should be between 0 to 50 degrees Celsius.
The relative humidity should be less than 90 percent, non condensing.
Surrounding
electrical
devices should not exceed the electromagnetic field (RFC)
standards for IEC 801 3, Level 2 (3V/M) field strength.
Make sure that the equipment receives adequate ventilation. Do not block the
ventilation holes on each side of the switch or the fan exhaust port on the side or
rear of the equipment.
Mounted to 19-inch standard rack
1.
Wear a grounding device for electrostatic discharge.
2.
Install screws through mounting ears into each side.
3.
Locate Converter Chassis at 19-inch mounting rails and screw up the front
brackets.
Desktop or any flat surface
1.
Simply put the chassis on the desired place.
2.
Ensure the chassis receives good ventilation.
The side-in Media Converter and Converter Chassis should be supplied only from
the same source; both Media Converter and Chassis are built to match each other at
dimensions, DC power jack, DC receptacle and power safety.
Verify the Media Converter is right for this Chassis and 5VDC power jack on
converter back, and carefully slide in and plug to match 19” rack slot +5VDC
receptacle.
Before connection with the power cord, please set the Power Switch at “OFF”
position.
Two power supplies, 12 converter modules and two 8cm DC fans are providing hot
swappable.
3