Then remove the power switch extension pushing rod. Unscrew and take
out the drive cage with the drives and remove the drives from it.
Now you take out the screw of the power supply at the backplane of the
case and pull out the power supply while moving it towards the front.
Then take off the extension-card holding bracket from the backplane (1
screw), remove the 2 hexagonal bolts of the Sub-D type SERIAL port. For
this you need a 5 mm plug-on-type key (or pliers). The other hexagonal
bolts are NOT removed.
Take out the 9 screws that hold the motherboard and take it out of the
case.
Please keep the screws as you can use them again.
The protective copper shielding around the Sub-D ports and the protectlve
plastic sheet underneath the mainboard are used again later.
ASSEMBLY INTO THE TOWER
First you remove the 6 screws at the back of the case and then take off
the lid moving it back and up. The tower frame is then to be layed
sideways onto the table.
The dust shielding door at the front of the tower can easily removed
temporarily by gripping it with both hands and bending it so far that you
can take the two hinge-bolts out of the seating.
Take out the bits and pieces underneath the doubled bottom of the card
board box of the busboard and sort them. Lay aside the 4 screws with
bigger threat measure, later you will mount the plinth of the tower with
them.
The rest of the screws has a metrical M3 threat.
3
