Compact Numeric Keypad - MP3393
Page 9 of 9
T_MP3393-Compact Numeric Keypad Leaflet_V1.3
MicroPace Numeric Keypad Kit #200MP3393
Installation Checklist
(Upon completion of the upgrade forward this completed document to
your company’s records department for retention or
fax to MicropaceEP on 714 258 7280)
Serial Number of Micropace StimCor, StimLab, or EPS320: _________________________________
Serial Number of Micropace MP3415 Keypad (located on rear): _____________________________
Facility Name: __________________________ Address: ___________________________________
Installed by: ________________________________________________ Date: __________________
Verify Compatibility
_____ Boot the system using a Standard Keyboard and clear any info messages by pressing ESC.
_____
Access Help menu and select “About the EPS320”
_____ Software is verified as
3.21
or above. Refer to IFU above for help.
Install the MP3415 Compact Numeric Keypad
_____ Turn off the system and connect the MP3415 Numeric Keypad.
Verify Installation & Training
_____
Verify correct installation by pressing “PACE” on the keypad. Pacing should commence.
NOTE:
If pacing does not commence, see “Troubleshooting” in this IFU.
_____ Verify that the local Touch Screen (MP3114) is enabled and accepting touch input correctly.
_____ No Y-Splitter or PS/2 to USB adapter is installed and the Keypad is connected only to a
Micropace Bona PC MP3093.
_____ Keypad labels are attached, visible, and correct (refer to product picture in IFU).
_____ No extension cable(s) longer than 10m is connected to the Numeric Keypad.
_____ User(s) has been provided with the Instructions for Use.
Signed: __________________________________________________Date: ____________________
