20
ADDITIONAL FUNCTION
RELATIVE ZERO SETTING
• Pushing down either one of the two Save buttons
for about three seconds,
you will enter in the
Relative zero configuration mode
on the instrument.
• Hold Archimede for about ten seconds in the desired position
for the relative zeroing.
After this procedure you will automatically return to the Measurement screen where the
saved position will correspond to the new zero in the instrument. On the screen the label
REL will appear at the top right to make it clear that the instrument is in the Relative zero
mode.
You can also save measures with relative zero and display them on the software as usual.
The value displayed on the software will correspond to the actual value of the
measure and not to the relative value.
To exit from the Relative zero mode just press either one of the two Save buttons
for
about three seconds. If the instrument is turned off while it’s in the Relative zero mode,
this mode must be configured again when you switch the instrument on.
