MD0013-004
Page 2 of 2
7. Place the cabled workstation in the
adjustable stand. Figure 3, below.
Place the rubber feet into the
receptacles on the Adjustable Stand.
Figure 3: Placing the Workstation 5 on
the Stand
8. When the workstation is fully
seated on the stand, turn the knobs
on the rear of the stand to the
‘Locked’ position as shown in
Figure 4, in the right column.
Figure 4: Locking the Workstation to the
Adjustable Stand
To provide additional security when the
unit is located in a public area, a pair of
17mm screws are provided with the
Adjustable Stand to secure the knobs in
the locked position.
9. Make sure the knobs are in the
‘Locked’ position and use the hex
wrench supplied in the workstation
loose parts kit to install the screws.
