Chapter 3
Menu Configuration
3-2
MS-5000 Multidrop Concentrator User’s Manual
3–Ser
ial
Conf
ig.
Using the Menu Configuration Program
Entering the Menu Configuration Program
1
To see the Main menu (figure 1-1), from a host or terminal connected to the
host port of the concentrator, enter
51<D>CR
.
2
Figure 3-1 Main Menu
•
51
is the code which every concentrator recognizes as its own address
•
<D>
is the command to enter the Main menu
•
CR
(carriage return) terminates the command
Note:
The carriage return is enabled as the default ETX character. If ETX is
undefined (nulled), then a time delay exceeding the intercharacter timeout must
be inserted before transmitting another command to a different address.
Note:
Caps Lock must be on during menu configuration.
1. See Table A-1, “ASCII Table with Control Characters,” on page A-3.
2. This command must be sent as a data block from the host or as a string from a softkey
because of the intercharacter timeout (default =12 ms).
Summary of Contents for MS-5000
