Gigabit Ethernet Switch – Quick Installation Guide
Page 8 of 9
_______________________________________________________________________________________________
©2017_MICROSENS GmbH & Co. KG_Küferstr. 16_59067 Hamm/Germany_www.microsens.com
Step 7:
Click OK to change the PC’s IP address.
3.
Power up the switch to be initially configured, and wait until it has finished its
start-up processes.
4.
Connect the PC to any port on the switch using a standard Ethernet cable, and
check the port LED on the switch to make sure the link status of the PC’s is OK.
5.
Run your Web browser on the PC; enter the factory default IP address, to access
the switch’s Web interface.
If your PC is configured correctly, you will see the login page of the switch as shown by
Figure 9 below.
Figure 8: Web Interface login page
If you do not see the above login page, please perform the following steps:
- Refresh the web page.
- Check to see if there is an IP conflict issue.
- Clean browser cookies and temporary internet files.
- Check your PC settings again and repeat step 2.
6.
Enter the factory default username and password in login page.
Click “Login” to log into the switch.