18
19
EN
EN
i
INFORMATION
• Remember that your hearing aid warns you through five beeps
when you need to change the battery.
• Remove the batteries if you will not use the hearing aid for a
prolonged period.
• Immediately replace weak batteries.
Do not throw the batteries in the garbage! Hand them in to
a hearing health professional so that the batteries are properly
eliminated without harming the environment.
Disconnection of the Hearing Aid
See Figure 5
DISCONNECT: To disconnect your hearing aids partially open the
battery compartment.
CONNECT: To connect your hearing aids close the battery
compartment.
Placement of the Hearing Aid
See Figures 6 and 7
1. Carefully insert the thin tube with the earmold or the adapter into
the ear without pushing it in too deeply.
2. Place the hearing aid behind the ear.
3. Check that the entire set is properly supported.
WARNING!
• Danger of injury from improper use of adapters or custom earmolds.
• If the adapter or the custom earmold remains in the ear, ask a
medical professional to extract it.
• Do not push the adapter or custom earmold with the thin tube too
deeply into the ear.
• Use the thin tube and the adapter or the custom earmold only in
the way described in this user’s manual.
EN
EN
Program Button
See Figure 8
On pressing the button, the program change will be performed
cyclically; you will hear some tones that will indicate to you in the
program it’s found.
Example: (Two tones
♪♪
, Program 2)
Follow the instructions of your hearing care professional to get the
most out of your hearing aids.
Each program will allow you to better adapt to the different
surroundings or situations of your daily life.
For example, your hearing aids can make use of these programs:
• Normal.
• Restaurant.
• Telephone*
• Traffic.
*Your hearing aids comply with standard IEC 60118-13 on electromagnetic compatibility.
Change of ear-hook and thin tube
Only Amplex BTE model
See Figures 10-11
Your hearing care professional should change the ear-hook or the
thin tube when necessary.
If you need to substitute the ear-hook or adapter without help,
carefully follow these instructions.
REMOVE: Turn the ear-hook 180º and remove the ear-hook from the
hearing aid.
INSERT: Firmly insert the ear-hook in the hearing aid, as indicated in
the illustration.
Check that the ear-hook has been fully engaged in the hearing
aid; if not then repeat the operation.
