MPX-Module 6
miriac SBC-S32V User Manual
V 1.1
46/81
© MicroSys Electronics GmbH 2017
6.5
Switches
The sliding switch GPU on the MPX-S32V module is used to disconnect the GPU
power pins to reduce power consumption, in case the GPU is not used. The other
sliding switch BMD is used to select between RCON controlled and serial boot
mode. Both switches are located at the PCB edge on the bottom of the MPX-S32V
module.
Any handling of these switches must be done exclusively using
nonconductive tools to avoid short circuits between carrier
board and module.
Figure 23: GPU switch
Figure 26: BMD Switch
Figure 25: GPU Power On (default)
Figure 24: GPU Power Off
