Introduction 2
miriac SBC-S32V User Manual
V 1.1
7/81
© MicroSys Electronics GmbH 2017
2
Introduction
Thank you for choosing the MicroSys SBC-S32V Single Board Computer system.
This manual should help you to get the best performance and details out all of its
features.
2.1
Safety and Handling Precautions
ALWAYS use the correct type and polarity of the power
supply!
DO NOT exceed the rated maximum values for the power
supply! This may result in severe permanent damage to
the unit, as well as possible serious injury.
ALWAYS keep the unit dry, clean and free of foreign
objects. Otherwise, irreparable damage may occur.
Parts of the unit may become hot during operation. Take
care not to touch any parts of the circuitry during
operation to avoid burns, and operate the unit in a well-
ventilated location. Provide an appropriate cooling
solution as required.
ALWAYS take care of ESD-safe handling!
Many pins on external connectors are directly connected
to the CPU or other ESD sensitive devices.
Make or break ANY connections ONLY while the unit is
switched OFF.
Otherwise, permanent damage to the unit may occur,
which is not covered by warranty.
There is no separate SHIELD connection.
All the metal sheaths of shielded connectors are
connected to GND.
Also, all mounting holes of the carrier board are
connected to GND.
The module’s mounting holes are not connected to GND
Take this into account when handling and mounting the
unit.
Table 3 Safety and Handling Precautions
