Introduction 2
miriac SBC-T1024 User Manual
V 2.3
9/70
© MicroSys Electronics GmbH 2017
2.4.2 Feature Changelist for HW Revision 2
The revision 2 of the carrier board provides new features:
■
Added LED driver with 4x RGB LEDs
■
Added 12 GPIOs (6x in / 6x out) addressable via I²C
o
Output voltage level maximum 24V (according to the input voltage
of the carrier board)
o
Input voltage range 24V maximum
■
Added SuperCap for RTC backup battery (CR2032 coin cell as assembly
option still available)
■
Added prerequisites for support of emBRICK devices
■
Added current shunt for current measurements
■
Added optional (by assembly option) support for onboard current
measurements of the CPU module consumption via I²C current sense
amplifier
■
Added LAN interrupt support
■
Added SMART CARD connector
■
Added optional (by assembly option) extension connector (for example for
additional GPIOs or graphic support if provided by the CPU)
■
Added mounting holes for the carrierboard
■
Added a fan connector
■
Added connector labeling (silkscreen) on the PCB
Some features were changed:
■
SerDes 6 and SerDes 7 lanes were swapped in order to achieve a wider
functional coverage within the MPX2 module family
o
SerDes 6 is now connected to the SATA connector (ST10)
o
SerDes 7 is now connected to the mPCIe / mSATA slot (ST7)
■
Improved power input section with filters
■
Improved mechanical mounting of the CPU module and mPCIe/ mSATA
cards
■
Replaced PCIe x1 edge card connector with second PCIe extension
connector
All manuals and user guides at all-guides.com
