2
6
Connect the power lead from the drive enclosure fans to
the matching power connector from the power supply on
the base unit. Again, these connectors are color-coded.
7
Mount the elevator assembly onto the Xpress base.
Lower the elevator onto the two alignment pins…
8
… then secure the elevator with the (2) thumbscrews
from inside the drive enclosure behind the elevator.
HINT:
The thumbscrews may go in easier if you pull up on
the elevator slightly while tightening the screws.
5
Route the SATA drive cables from the base unit up to
the drive enclosure, and connect each to its respective
drive. The cables are tied so that each goes to a specific
drive.
