40 NDT-2000 User's Manual
5. Next, use a dust blower or a lint-free
cloth to clean components in the
hollow part beneath where the glass is
stored.
6. After cleaning the glass and the
components, along the tracks,
push back the glass surface until
it snaps into place.
Make sure that the installed
glass has been set at its proper
position; otherwise, the system
may detect that you are using
a multi-channel feeder
falsely
and then come out a warning
message.
NOTE
:
• Do not use any detergents, synthetic cleaning solutions, cleaning naphtha,
or other solvents to clean the glass surface or diffuser directly. To remove
stains, use supplied cleaning cloth moistened with optical lens cleaner (e.g.
Purosol Lens Cleaner).
• Wipe off dirt and stains from the surface of the glass horizontally while
cleaning. Do not wipe them vertically in order to avoid dropping off dirt or
stains into the interior of the scanner.
• While cleaning, wipe the glass only toward the same direction. Do not wipe
back and forth over the surface of the glass.
• When cleaning the surface of the glass, make sure that the cloth in use is
clean. After you wipe off dirt and stains each time, make sure to fold the
cloth to a clean side or use another clean cloth to continue cleaning. Do not
keep on using the dirty side of the cloth to clean in order to avoid the glass
surface getting dirty again.
