Chapter 11 Maintenance
11.4 Maintenance of the antenna socket
The optional "myDatanet service kit (206.324 )" equipment is required for maintaining the antenna
socket.
Important note:
l
The three small O-rings must be installed on the contact pin of the antenna socket to
improve the seal.
l
The O-rings must be checked after the antenna has been removed (e.g. when replacing
the rechargeable battery) and must be replaced with new ones from the myDatanet
service kit (206.324 ) in the event of brittleness or damage.
Installation of the three small O-rings
1 0.75x1.2 mm O-ring (included in the scope of
delivery of the 206.324 )
1. Place the three small O-rings on the contact pin of the antenna socket. The O-rings are placed
in the end position during initial assembly of the antenna.
11.5 Maintenance of the antenna connector
The optional "myDatanet service kit (206.324 )" equipment is required for maintaining the antenna
connector.
Important note:
l
The O-ring must generally be used for all radio receiver antenna connectors to improve
the seal and must be replaced as necessary.
l
The O-ring must be checked after the antenna has been removed (e.g. when replacing
the rechargeable battery) and must be replaced with a new one from the myDatanet
service kit (206.324 ) in the event of brittleness or damage.
Rev. 01
119