2. If you are using an external supply or charging voltage, disconnect this from the device before opening
the housing cover.
3. Remove the four screws that secure the housing cover. Now open the myDatalogEASY V3 .
4. Remove the power supply unit from the myDatalogEASY V3 and replace the existing power supply
unit with a new one. Use the strap provided to remove the power supply unit.
Note:
Ensure that power supply units, especially ones with integrated energy store
(rechargeable battery or battery), are disposed of in line with environmental requirements.
Power supply units with depleted rechargeable battery or battery can be returned to the
manufacturer or handed in at suitable collection points.
Removing the power supply unit
1
Power supply unit
2
myDatalogEASY V3 base unit
The following step is not mandatory.
5. Check whether the connection to the myDatanet functions correctly (see "Testing communication with
6. Close the housing cover. The best option is to tighten the four screws crosswise (torque: 0,5Nm; At the
first screw 0,7Nm because the threads have to be shaped into the base part first.) so that the housing
cover is positioned evenly.
Important note:
Ensure that the seals are clean and intact before closing the housing cover.
Remove any impurities and/or dirt. The manufacturer shall not be liable for any damage to the
device caused by leaky or faulty seals.
248
Rev. 05
Summary of Contents for myDatalogEASY V3
