Type plates myDatalogEASY V3
Note:
This symbol indicates the country list profile (see www.microtronics.com/footprint) of the SIM chip
installed in the device.
Note:
These operating instructions are part of the device and must be available to the user at all
times. The safety instructions contained therein must be observed.
WARNING:
It is strictly prohibited to disable the safety equipment or modify its mode of operation.
4.9 Installation of spare and wear parts
Be advised that spare and accessory parts that have not been supplied by the manufacturer have also not
been inspected or approved by the manufacturer. The installation and/or use of such products can possibly
have a negative impact on the specified constructional properties of the device. The manufacturer shall not be
liable for any damages that arise from the use of non-original parts and non-original accessory parts.
4.10 Storage of the product
For safekeeping of the myDatalogEASY V3 , ensure that all relevant data was transferred to the myDatanet
server. If necessary, initiate a transmission directly on the device using the solenoid contact (see "Solenoid
switch" on page 81), if you have included this in your Device Logic, and then check again to see whether all of
the relevant data has now been transferred. If your device does not include the option to initiate the
transmission of temporarily stored measurement data, you may have to wait until the next scheduled data
transmission for all of the data to be sent to the myDatanet server. This particularly applies to the "interval"
connection type (see "rM2M_TxSetMode()"). If the "Interval & wakeup" connection type has been selected,
you can initiate the transmission via the myDatanet server. Then check again to make sure all of the relevant
data has been transferred. With the "Online" connection type, the determined measurement data is
immediately transferred to the myDatanet server. The data on the server is always up-to-date and the device
can be switched off at any time. Remove the power supply unit before disconnecting the cables and antenna.
If possible, switch off the supply or charging voltage before disconnecting the cables from the V IN and GND
clamps (see "Connecting the sensors, actuators and power supply" on page 60). Store the
myDatalogEASY V3 and power supply unit in the original packaging.
The configuration and most recently determined data are retained. The system time also continues to run
thanks to the hardware real-time clock equipped with its own buffer battery. This means that a valid time basis
is available immediately following recommissioning (see "Technical details about the system time" on page
75).
26
Rev. 05
Summary of Contents for myDatalogEASY V3
