Chapter 7 Installation
6. Connect the antenna (see "Connecting the GSM antenna" on page 64). The antenna is not included in
the scope of delivery and must be ordered separately.
7. Insert the power supply unit.
The following step is not mandatory.
8. Check whether the connection to the myDatanet has worked correctly (see "Testing communication
9. Close the housing cover. The best option is to tighten the four screws crosswise (torque 0,5Nm; At the
first screw 0,7Nm because the threads have to be shaped into the base part first.) so that the housing
cover is positioned evenly.
Important note:
Ensure that the seals are clean and intact before closing the housing cover.
Remove any impurities and/or dirt. The manufacturer shall not be liable for any damage to the
device caused by leaky or faulty seals.
Closing the housing cover
1
myDatalogEASY V3 base unit
3
Housing cover
2
Delta PT M3.5x25 Torx 15
10. Check that the housing cover is positioned correctly on all sides and that no foreign materials have
been trapped between the housing and housing cover.
Important note:
The manufacturer is not liable for any damage that is caused by housing
covers that are not closed correctly.
Rev. 05
63
Summary of Contents for myDatalogEASY V3
