5. Wait until the measurement instrument list indicates that the device is connected to the server (rotating
arrows).
With the exception of the "Online" connection type (see "rM2M_TxSetMode()"), the time during which
the myDatalogEASY V3 is connected to the server is very short. It can therefore also be checked
whether the time stamp of the last connection (under the green status symbol) has been updated.
The following steps are only necessary, if you simultaneously want to test the measurement value acquisition
and data transmission.
6. Complete all of the steps detailed in the chapter "Assembling the myDatalogEASY V3 " on page 47.
This includes connecting the sensors.
Important note:
All wiring work must be performed in the de-energised state.
7. You can use the "Reports" of the myDatanet server to check the data transmission (see "myDatanet
Server Manual " 805002). The configuration of the Data Descriptor (see "Data Descriptor " on page
235) is required for this purpose.
8. Once you have completed the necessary preparations, initiate a transmission directly on the device if
you have included this in your Device Logic. If you have not included an option to trigger a transmission,
wait for the next scheduled data transmission.
9. Evaluate the incoming data.
80
Rev. 05
Summary of Contents for myDatalogEASY V3
