3. Then connect your sensors and actuators with the universal inputs and outputs. If you are
using an rechargeable battery pack to supply the myDatalogEASYplus , connect the external
charging voltage to V
in
and GND. Ensure that no current is present!
Important note: Only a single cable must be threaded through the cable screw
connections to ensure the seal of the housing is not jeopardised.
Important note: Ensure that the polarity is correct when using an external charging
voltage. The charge controller of the myDatalogEASYplus can be damaged or destroyed
by polarity reversal.
4. Tighten the cable screw connections to secure the cables.
5. Affix blind plugs to all of the cable screw connections that are not required.
Important note: All unused cable screw connections on the myDatalogEASYplus must
be sealed watertightly using the blind plugs supplied. Otherwise the degree of
protection for the entire device is not guaranteed and the manufacturer's warranty is
void.
6. Insert the rechargeable battery or battery pack into the myDatalogEASYplus and secure it with
the appropriate mounting.
7. Connect the antenna (see "Connecting the GSM antenna" on page 54). The antenna is not
included in the scope of delivery and must be ordered separately.
8. Connect the rechargeable battery or battery pack to the supply connector. The status LED
should then start to flicker (see "Status LED" on page 63), indicating that a connection is
being established.
The following step is not mandatory.
9. Check whether the connection to the myDataweb has worked correctly (see "Testing
communication with the device" on page 60).
10. Close the housing cover. Tighten all four of the screws crosswise so that the housing cover is
positioned evenly.
Important note: Ensure that the seals are clean and intact before closing the housing
cover. Remove any impurities and/or dirt. The manufacturer shall not be liable for any
damage to the device caused by leaky or faulty seals.
The following step is only necessary if you are using an external charging voltage for the
rechargeable battery pack:
11. Now switch on the external charging voltage.
52
Rev. 06
Summary of Contents for myDatalogEASYplus
