"Digital"
or "digital
LP" mode
Event
trigger
MS
Start measurement cycle immediately
XM
Initiate transmission
Edges
Selection of the edge at which the trigger should be initiated
rising
Rising edge initiates the trigger.
falling
Falling edge initiates the trigger.
both
Both edges initiate the trigger.
Level
trigger
QU
Fastrecording (record interval = record interval / factor)
SL
Slow recording (record interval = record interval * factor)
ON
Activate online mode
QX
The reduced transmission cycle should be used.
Edges
not relevant for the level triggers
All other modes
QU
Fastrecording (record interval = record interval / factor)
SL
Slow recording (record interval = record interval * factor)
RO
Switch on recording
RF
Switch off recording
XM
Initiate transmission
ON
Activate online mode
QX
The reduced transmission cycle should be used.
Level
Levels for initiating the trigger. The hysteresis from the "Alarm"
tab is used to determine the level to reset the trigger.
Greater or
equal
The measurement value must be greater or
equal to the level to initiate the trigger.
Less or equal
The measurement value must be less or equal
to the level to initiate the trigger.
9.2.1.4 Calculated channels
Note: The values of the calculated channels are directly calculated for every data output (display on the myDatanet
server or download from the myDatanet server). They are not saved in the server database.
9.2.1.4.1 Basis
Title 1-5
Freely selectable channel title for the calculated channels [0-16 characters]
84
Rev. 06
Summary of Contents for myDatalogEASYplus
