Problem
Cause/solution
Fill level is not plausible.
l
Check whether there are any kinks in the cable between the BLE Gauge
and the pressure sensor or whether the bend radius has fallen below the
minimum permissible value of 60mm .
l
Check the pressure compensation membrane of the BLE Gauge for any
impurities (see "Overview" on page 27).
l
Check whether the inlet openings of the pressure sensor are blocked (see
"Overview" on page 27).
Alarm state of a
measurement value
was not detected.
l
Increase the record interval (attention: This will increase the required data
volume).
Alarm state was not
transferred although the
data is present.
l
Check the alarm settings of the measurement channel
l
The connection was aborted during the transmission, which is indicated by a
time-out entry in the connection list (see "myDatanet Server Manual "
805002). Solution: Activate setup mode or wait for the next cyclical
transmission.
Alarm message was not
sent although the alarm
was signalled.
l
Check the settings of the alarm schedule (see "myDatanet Server Manual "
805002).
l
Check the address data of the alarm schedule (see "myDatanet Server
Manual " 805002).
142
Rev. 01
Summary of Contents for myDatalogGauge 3G
