Chapter 6 Functional principle
7. Evaluate the result of setup mode. If setup mode was completed successfully, the determined values
for the GSM level are illustrated by the black dots that are connected by a line. If the measurement
values are not in the green (very good or good) or yellow (OK) area, we recommend improving the
position of the antenna and activating setup mode again. If a problem is detected, the note "Setup
mode failed (enhance antenna position)" is shown above the GSM level display.
Note:
Information on improving the reception quality is provided in chapter "Optimum antenna
positioning for assembly in a shaft" on page 62.
Display of the GSM level determined during setup mode
1
Position of antenna is OK
2
Position of antenna should be improved
Note:
Once terminated, the result of setup mode is shown up for a period of 5min. on the
display of the device. You may need to activate the display again by briefly holding the magnet
(approx. 1 sec.) to the reed switch again (see "Reed switch" on page 75).
Position of antenna is OK.
Position of antenna should be
improved.
Problem detected
Rev. 01
45
Summary of Contents for myDatalogGauge 3G
