Chapter 8 Installation
8.3 Electrical installation
Important note:
Only qualified personnel should undertake the installation described in this chapter
of the operating instructions to avoid any damage to the device.
8.3.1 Inserting the activation module
Note:
Transport mode is terminated when inserting the activation module, i.e. the
measurement/recording and cyclical data transmission are activated. It is therefore recommended
that the activation module is only permanently inserted as part of the commissioning process (see
"Placing the system into operation" on page 65). However, briefly inserting the activation module in
the office, to check the functionality of the myDatalogGauge 3G , is still advisable. Storage with the
activation module inserted is not recommended due to the significantly increased power consumption
when transport mode is deactivated.
The activation module is inserted in the sensor recess of the myDatalogGauge 3G , as illustrated in the
following figure. It is designed in such a way that it cannot be inserted incorrectly.
Inserting the activation module
1
Activation module
2
Sensor recess of the myDatalogGauge 3G
Transport mode is deactivated, the display is activated and the following actions are executed when the
activation module is inserted:
Note:
To check the current operating state, you may need to activate the display again by holding the magnet
(approx. 1 sec.) to the reed switch again (see "Reed switch" on page 75).
1. The BLE connection between the data logger "BLE & 3G Gateway ATEX " and up to 2 BLE Gauge
sensor modules is established.
Rev. 01
61
Summary of Contents for myDatalogGauge 3G
