Chapter 9 Initial Start-Up
9.5.2 Testing communication between the myDatalogGauge 3G and the myDatanet
server (Bluetooth connection)
1. Within the desired customer, create a new site/application based on the IoT application
"myDatalogGauge" for operation of the myDatalogGauge 3G on the myDatanet server (see "Creating
the site" on page 131).
2. Configure the created site/application according to your requirements (see "Site configuration" on page
79).
The following settings should be carried out if you also want to test the communication with the BLE
Gauge sensor module at the same time:
1. Activate the required measurement channels by selecting the mode and specifying the serial
number of the BLE Gauge (see "Measurement channels" on page 83).
2. Check or enter the installation height of the pressure sensor in the input field for the "Sensor
Offset" parameter (see "Measurement channels" on page 83).
3. Check or enter the value for the zero point adjustment in the input field for the "Trimming"
parameter (see "Measurement channels" on page 83)
3. Insert the activation module in the sensor recess of the myDatalogGauge 3G (see "Inserting the
activation module" on page 61).
4. Use the DeviceConfig configuration program to establish a Bluetooth connection (Bluetooth Low
Energy) between the myDatalogGauge 3G and your PC (see "Establishing a connection to a device
with Bluetooth Low Energy interface" on page 108).
5. Activate the synchronisation between myDatalogGauge 3G , DeviceConfig and the myDatanet
server. To do so, initially select the "Sync with server" checkbox and then click on the button illustrated
below. The checkbox and button are both located on the "Sync" tab of the DeviceConfig configuration
program (see ""Sync" tab" on page 112).
Note:
The "Sync with server" checkbox is only displayed if your PC is already connected to the
Internet.
6. Wait until some measurement values have been recorded. The waiting time depends on the configured
record interval (see "Basic settings" on page 92).
7. Trigger the synchronisation between myDatalogGauge 3G , DeviceConfig and the myDatanet server
to transmit the recorded fill level measurement values to the myDatanet server.
Rev. 01
73
Summary of Contents for myDatalogGauge 3G
