10.2.1.1.8 Basic settings
"Basic settings" configuration section
1
Time between transmissions
2
Time between the transmissions, if a alternative transmission cycle should be used because of a trigger
being initiated
3
Time between measurement data recordings
4
Time between measurement data recordings, if an alternative record interval should be used because of
a trigger being initiated
5
Regional settings (not relevant for raw measurement data as this is stored in UTC)
6
Configuration for automatic time adjustment
Standard
The configuration for the time adjustment is adopted by the global server setting (siehe
"myDatanet Server Manual " 805002).
Off
Automatic time adjustment deactivated
USA
Predefined setting for the American area
EU
Predefined setting for the European area
7
Position update interval (00:00 positioning is completed with every connection)
8
Selection of the report that is loaded by clicking on the device link in the maps
Off
No report is loaded.
"Name of a
report"
The selected report is loaded.
92
Rev. 01
Summary of Contents for myDatalogGauge 3G
