Chapter 9 User interfaces
Chapter 9 User interfaces
The configuration of the myDatalogNANO Ex is carried out via the web interface on the myDatanet
server (see "User interface on the myDatanet-Server" on page 59), which your responsible sales
partner will provide to you.
9.1 User interface on the myDatalogNANO Ex
9.1.1 Operating elements
The operating elements of the myDatalogNANO Ex can still be operated when the housing is closed.
Operating elements
1 Solenoid switch
2 Status LED
9.1.1.1 Solenoid switch
The MDN Magnet (206.803), that is available as an accessory, is required to operate the solenoid
switch. The solenoid switch can be used to initiate the ALOHA transmission mode or to instruct the
myDatalogNANO Ex to immediately issue the error/status code.
Operation by the
user
Device response
Operation after releasing the solenoid
switch
Press briefly
(approx. one
second)
Status LED illuminates
Error/status code is issued (see "Status
LED" on page 58)
Press and hold for
five seconds
Status LED flashes three times and
then remains on
ALOHA transmission mode
Rev. 01
57
Summary of Contents for myDatalogNANO Ex
