10.12 Recommended procedure
10.12.1 Synchronisation with the DeviceConfig configuration program
The following process describes how you can read out the data from the myDatasensMINI H2S
1000using the DeviceConfig configuration program so that it can be processed locally. If you wish to
synchronise the data with the myDatanet server at a later date, this is possible at any time (see "No
connection to a device" on page 60).
1. Connect the USB radio transmitter (206.657) to the USB interface of your PC.
2. Start the DeviceConfig configuration program.
DeviceConfig
3. Connect the myDatasensMINI H2S 1000to the PC using the USB radio transmitter (206.657)
supplied (see "Establishing a connection to a device with a wireless M-bus interface" on page
49).
4. Additional tabs are displayed if the connection was established successfully. Now select the
"Sync" tab.
myDatasensMINI H2S 1000specific tab
64
Rev. 01
Summary of Contents for myDatasensMINI H2S 1000
