MICROTRONIX DX-2200-SW-02 User Manual Download

Page: 45 / 87

DX-2200

– Dual-view 2x1 SDI Video Switcher

Page 45 of 87

Command

Code

Mode of Operation

SnnFBwwww

For Graphic Field nn, set the fill width (in pixels) associated with the bottom
line of a rectangle.
wwww is a number between 1 and 4 digits in length. A width of zero means
there is no fill associated with the bottom line.

SnnWxxxx,yyyy

Set the Width parameter of Graphic Field nn to the value xxxx for the x
direction and to the value yyyy for the y-direction.
xxxx and yyyy are numbers between 1 and 4 digits in length.
For Rectangles, Width is the number of pixels drawn in the line color at the
perimeter of the rectangle. Any remaining pixels inside the rectangle are the
fill region and are drawn with the fill color (if drawing of the fill is enabled). If
width is zero, the entire rectangle is drawn in the line color.
For Corner markers, Width is the width in pixels of the lines that make up the
corner markers.
For the Target Marker, Width is the width in pixels of the vertical and
horizontal lines that form the Target Marker. Width has a resolution of two
pixels so that the target marker is always symmetrical with ½ the width drawn
on each side of the center.

SnnWwwww

Set the Width parameter of Graphic Field nn to the value wwww for both x and
y directions. wwww is a number between 1 and 4 digits in length.

SnnWLwwww

For field nn, set the Line width of the left side of a rectangle to the value
wwww.
wwww is a number between 1 and 4 digits in length. A width of zero causes
the left line to be suppressed.
Note: This command has no effect for corner marker or target fields

SnnWRwwww

For field nn, set the Line width of the right side of a rectangle to the value
wwww.
wwww is a number between 1 and 4 digits in length. A width of zero causes
the right line to be suppressed.
Note: This command has no effect for corner marker or target fields

SnnWTwwww

For field nn, set the Line width of the top side of a rectangle to the value
wwww.
wwww is a number between 1 and 4 digits in length. A width of zero causes
the top line to be suppressed.
Note: This command has no effect for corner marker or target fields

SnnWBwwww

For field nn, set the Line width of the bottom side of a rectangle to the value
wwww.
wwww is a number between 1 and 4 digits in length. A width of zero causes
the bottom line to be suppressed.
Note: This command has no effect for corner marker or target fields

SnnLxxxx,yyyy

Set the Length parameter of Graphic Field nn to the value xxxx for the x
direction and to the value yyyy for the y-direction.
xxxx and yyyy are numbers between 1 and 4 digits in length.
For Corner Markers, Length is the distance in pixels each marker extends
from each corner.
For the Target Marker, length is the length in pixels of the horizontal and
vertical lines and has a resolution of 2 pixels so that the Target Marker is
always symmetrical with ½ the length on each side of the center point.

SnnLaaaa

Sets the Length parameter of Graphic Field nn to the value aaaa for both x
and y directions. aaaa is a number between 1 and 4 digits in length.