MICROTRONIX DX-2200 User Manual Download

Page: 41 / 103

DX-2200

– SD/HD-SDI Text & Graphics Inserter – User Manual

Page 41 of 103

Command Code Mode of Operation

GnnWxxxx,yyyy

For the active graphics layer, set the Width parameter of Graphic Field nn to the value
xxxx for the horizontal direction and to the value yyyy for the vertical-direction.
xxxx and yyyy are numbers between 1 and 4 digits in length.
For Rectangles, Width is the number of pixels drawn in the line color at the perimeter
of the rectangle. Any remaining pixels inside the rectangle are the fill region and are
drawn with the fill color (if drawing of the fill is enabled). If width is zero, the entire
rectangle is drawn in the line color.
For Corner markers, Width is the width in pixels of the lines that make up the corner
markers.
For the Target Marker, Width is the width in pixels of the vertical and horizontal lines
that form the Target Marker. Width has a resolution of two pixels so that the target
marker is always symmetrical with ½ the width drawn on each side of the center.

GnnWwwww

For the active graphics layer, sets the Width parameter of Graphic Field nn to the value
wwww for both horizontal and vertical directions. wwww is a number between 1 and 4
digits in length.

GnnWLwwww

For field nn on the active graphics layer, set the Line width of the left side of a
rectangle to the value wwww.
wwww is a number between 1 and 4 digits in length. A width of zero causes the left line
to be suppressed.
Note: This command has no effect for corner marker or target fields

GnnWRwwww

For field nn on the active graphics, set the Line width of the right side of a rectangle to
the value wwww.
wwww is a number between 1 and 4 digits in length. A width of zero causes the right
line to be suppressed.
Note: This command has no effect for corner marker or target fields

GnnWTwwww

For field nn on the active graphics layer, set the Line width of the top side of a
rectangle to the value wwww.
wwww is a number between 1 and 4 digits in length. A width of zero causes the top line
to be suppressed.
Note: This command has no effect for corner marker or target fields

GnnWBwwww

For field nn on the active graphics layer, set the Line width of the bottom side of a
rectangle to the value wwww.
wwww is a number between 1 and 4 digits in length. A width of zero causes the bottom
line to be suppressed.
Note: This command has no effect for corner marker or target fields

GnnLxxxx,yyyy

Set the Length parameter of Graphic Field nn to the value xxxx for the x direction and
to the value yyyy for the y-direction.
xxxx and yyyy are numbers between 1 and 4 digits in length.
For Corner Markers, Length is the distance in pixels each marker extends from its
corner.
For the Target Marker, length is the length in pixels of the horizontal and vertical lines
and has a resolution of 2 pixels so that the Target Marker is always symmetrical with ½
the length on each side of the center point.

GnnLaaaa

Sets the Length parameter of Graphic Field nn to the value aaaa for both x and y
directions. aaaa is a number between 1 and 4 digits in length.