22
MDS iNET 900 Series User’s Guide
MDS 05-2806A01, Rev. E.1
A unique IP address and subnet are required to access the browser-based
Management System either through the
LAN
port, or remotely
over-the-air.
2.6
STEP 5—CONNECT LAN AND/OR
SERIAL EQUIPMENT
Connect a local area network to the
LAN
port or serial devices to the
COM1
(DCE) or
COM2
(DTE) ports. Make sure your transceivers are
capable of supporting your devices. (
See Table 1-1 . Transceiver Models
and Data Interface Services, on page 5
for a summary of model capabil-
ities.) The
LAN
port will support any Ethernet-compatible equipment.
This includes devices that use the Internet Protocol (IP).
NOTE:
If you configure COM1 for payload data service while you are
plugged into it, you will not be able to access the management
system. Alternate methods for accessing the management
system are: use Telnet or the web browser through the Ethernet
port; use Telnet or the web browser through the antenna port
(remote management).
Figure 2-3 on Page 23
shows the default functions and services for the
interface connectors.
Table 2-1. Basic Configuration Defaults
Item
Menu Location
Default
Values/Range
Device Mode
1
Main Menu>>
Network Configuration>>
Device Mode
Marked on unit’s
ID label
• Access Point
• Dual Remote
• Serial Gateway
• Ethernet Bridge
Network Name
Main Menu>>
Network Configuration>>
Network Name
“Not
Programmed”
• 1–15 alphanumeric
characters
• Case-sensitive;
can be mixed case
IP Address
Main Menu>>
Network Configuration>>
IP Address
192.168.1.1
Contact your network
administrator
RF Output
Power
Main Menu>>
Radio Configuration>>
RF Output Power
30 dBm (1.0
Watt)
20–30 dBm @ 50
Ω
(0.1–1.0 Watts)
Unit Password
Main Menu>>
Device Information>>
User Password
admin
(lower case)
• 1–8 alphanumeric
characters
• Case-sensitive;
can be mixed case
1. Ethernet Bridge and Serial Gateway will not be displayed if a superior mode is autho-
rized for this unit.
Summary of Contents for iNET 900 Series
