11 |
Service settings
13.Receiving unit
00 07 B1 01
00 07 B1 A2
SEEK
-> FINISHED
Service part
13. Receiving (switching) unit
In this window it is possible to allocate one or more switching units to the unit of measure.
The function is chosen by wheel revolution and arrow moving in up and down directions and
by pressing the wheel the function gets activated. After the first entry into this window, the
network addresses of switching units chosen yet are displayed. At this point it is possible to
leave the window without any parameter changes by choosing ,,FINISHED´´ item.
After choosing the SEEK function the searching for accessible switching units get started, the
network addresses of found units are displayed in the window. By moving the arrow to the
requested address and pressing the wheel, this unit can be chosen for receiving, by pressing
it once more the choice is cancelled. The unit choosing is signalized by a pipe next to the
network address. The chosen addresses must be confirmed by ,,FINISHED´´ item.
If there is not any network address chosen in the measuring unit, the unit will control the first
accessible switching unit.