6 |
U s e r ´ s a n d i n s t a l l a t i o n m a n u a l
D R Y S I R E N
P a g e 6 o f 6 8
V e r s i o n : 0 1 / 2 0 1 8
SW
IM
M
IN
G
P
O
O
L
D
EH
U
M
ID
IF
IE
R
DR
Y
S
IR
E
N
3.3
HANDLING PRECAUTIONS
Leave the compressor unit in vertical upright position for at least 2 hours before the installation. This will
level the oil inside the compressor.
Transport of the compressor unit in lying position or turning the compressor unit over may harm the
compressor and will lead to loss of warranty.
The device must be handled with care and special attention avoiding any mechanical damage.
It is forbidden to apply any improper mechanical force onto the unit. This may cause mechanical damage to
the device.
It is forbidden to let the device fall freely onto the ground or any solid surface resulting in hard impact.
Please notify your reseller or distributor if you suspect that the unit was delivered damaged. Unit may seem
to work well at start but small damage can make the unit go out-of-order in short time. In such case the unit
must be inspected and approved for further use by your reseller.
Please notify your reseller or distributor if directly after installation you suspect that unit is not working in
perfect order.
In the case of device failure resulting from improper handling or mechanical damage (impact, hit, fall, etc.),
the manufacturer reserves the right to evaluate the continuity of warranty.