D R Y S I R E N
U s e r ´ s a n d i n s t a l l a t i o n m a n u a l
|
61
P a g e 6 1 o f 6 8
V e r s i o n : 0 1 / 2 0 1 8
SW
IM
M
IN
G
P
O
O
L
D
EH
U
M
ID
IF
IE
R
D
R
Y
S
IR
E
N
locate the DRY SIREN –
‘DRY SIREN ID’
No internet connection Check your internet connection. Check your
WIFI network password. Check that you have
internet connection. Sometimes your WIFI
network signals properly but your WIFI router
does not have internet access. This may the
case of malfunction of your ISP (Internet
Service Provider) service, hardware problem,
etc. Some ISPs tend to turn your internet
connection off if your bill is overdue.
Alternatively restart your WIFI router.
Incorrect internet
password
Check your WIFI network password.
Incorrect DRY SIREN or
Mobile application log-
in password
Check the passwords on DRY SIREN LICENCE
PLATE.
Temporary server
unavailability
Please wait 5 minutes and repeat the
procedure. If you wait longer than 15minutes
and the pairing does not work, contact your
distributor or reseller.
I am unable to
control my DRY
SIREN.
Internet connection
problem / pairing
problem.
Failure ‘DS
UNREACHABLE’ shown
in application. Once
you see this error,
please wait 5-10
seconds. Sometimes
when response from
server due to internet
connection is slower,
temporarily (max.
10seconds) the DRY
SIREN may be
‘UNREACHABLE’.
1. Check your WIFI network is working and
that is it connected to the internet.
Sometimes your WIFI network signals
properly but your WIFI router does not have
internet access. This may the case of
malfunction of your ISP (Internet Service
Provider) service, hardware problem, etc.
Some ISPs tend to turn your internet
connection off if your bill is overdue.
2. Check power supply to the ceiling and
compressor unit.
3. Restart the DRY SIREN by turning the circuit
breaker off and on again. Please allow 60
seconds to boot the unit.
4. Perform pairing process. Please turn to
section 11 UNIT TEST – PAIRING.
DRY SIREN does
not respond to
commands set by
application.
You change settings in
application but DRY
SIREN does not react.
1. Please allow between 1 and 5 seconds to
process a command. The time needed to
process a command depends on your internet
connection. If command is not processed
correctly you are advised by a pop-up
message ‘ERROR IN SENDING COMMAND’.
2. Make sure you are commanding correct
DRY SIREN – please turn to DRY SIREN Serial
Number shown in application and compare it
to the serial number on a Compressor unit.