Chapter 4: Using the Command Line Interface
156
To enable the front panel outlet control feature:
config:#
security frontPanelPermissions add switchOutlet
To disable the front panel outlet control feature:
config:#
security frontPanelPermissions remove switchOutlet
Enabling or Disabling Front Panel Actuator Control
The following CLI commands control whether you can turn on or off a connected actuator by operating the front panel
display.
To enable the front panel actuator control feature:
config:#
security frontPanelPermissions add switchActuator
To disable the front panel actuator control feature:
config:#
security frontPanelPermissions remove switchActuator
Tip: If your PDU supports multiple front panel permissions, you can combine them into one command by adding a
semicolon (;) between different permissions. For example, the following CLI command enables both front panel actuator
control and outlet switching functions simultaneously.
security frontPanelPermissions add switchActuator;switchOutlet
Examples
This section illustrates several security configuration examples.
Example 1 - IPv4 Firewall Control Configuration
The following command sets up two parameters of the IPv4 access control feature.
config:#
security ipAccessControl ipv4 enabled true defaultPolicyIn accept
defaultPolicyOut accept
Results:
•
The IPv4 access control feature is enabled.
•
The default policy for inbound traffic is set to "accept."
•
The default policy for outbound traffic is set to "accept."