Page 3
HARDWARE INSTALLATION
Rackmount Installation
WARNING
: Unplug and allow the unit to fully discharge before performing installation steps.
AVERTISSEMENT
: Débranchez et laissez l'appareil se décharger complètement avant peforming étapes d'installation.
WARNING
: For safety instructions, refer to the “Online UPS User Manual” via the link provided on the first page of this guide.
AVERTISSEMENT
: Pour obtenir des instructions de sécurité, se reporter à la "Online UPS User Manual" via le lien ou le code de QR fourni sur la
première page de ce guide.
NOTE
: Some rackmount steps are pictured with the Online Expansion Battery. The rackmount mounting procedure is the same for both products.
1.
Turn off and unplug the unit.
2.
Remove the (7) dust covers by prying them from the screw
holes.
3.
Install (2) rackmount ears using (8) M5x7L flat head
screws. Also, install (2) hanging brackets using (6) M5x6L
pan head screws.
4.
Install your rackmount rails. The rails adjust to mount in
48cm (19”) panel racks from 52 to 91.5cm (20.5 to 36”)
deep. Select the proper holes in the rack for positioning
the UPS in the rack. The UPS takes up positions 1 through
6.
5.
Adjust the rackrail depth within specified mounting ranges
from step 4. Attach the rackmount rail to your rack with (8)
10-32x1/2L screws and (2 screws for both front and back
and for each rail). Tighten all screws.
6.
Slide hanging brackets on the UPS into the rails mounted
in the rack with the front of the unit facing you. Secure the
UPS to your rack with (4) 10-32x1/2L screws on the front
of the rack (located in positions 2 and 5).
Position 6
Position 5
Position 2
2U Front
Installation
Position 6
Position 5
Position 4
Position 3
Position 2
Position 1
For
Rackmount
Ears
For Rails
2U Rear
Installation
Position 6
Position 5
Position 4
Position 3
Position 2
Position 1
For Rails
Position 1
Position 5
Position 2
Summary of Contents for UPS - OL1500R
Page 8: ......
