INSTALLATION & OPERATION MANUAL, ELECTRIC COUNTER PAN STEAMERS, EPXN-3, EPXN-5
8.0 TROUBLESHOOTING
(Continued)
Door Gasket Replacement
4. Install the new door gasket to the door panel. Replace the gasket plate and six or eight
screws.
5. Gasket replacement is now complete.
Door may be difficult to close until gasket has compressed to conform to opening. Leaving door
closed overnight will compress gasket.
Exterior Panel Removal
WARNING: To prevent hazard in servicing the cooker, be certain
that the electrical disconnect circuit breaker for the steamer is OFF
before removing side panels.
Access to all internal plumbing and electrical assemblies is from the right side. The right-side
panel is removed by removing the bottom screws from panel.
STAINLESS STEEL
To remove normal dirt, grease or product residue from stainless steel, use ordinary soap and
water (with or without detergent) applied with a sponge or cloth. Dry thoroughly with a clean
cloth. Never use vinegar or any corrosive cleaner.
To remove grease and food splatters or condensed vapours that have baked on the equipment,
apply cleanser to a damp cloth or sponge and rub cleanser on the metal in the direction of the
polishing lines on the metal. Rubbing cleanser as gently as possible in the direction of the
polished lines will not mar the finish of the stainless steel.
NEVER RUB WITH A CIRCULAR
MOTION.
Soil and burnt deposits which do not respond to the above procedure can usually be removed
by rubbing the surface with
SCOTCH-BRITE
scouring pads or
STAINLESS
scouring pads.
DO
NOT USE ORDINARY STEEL WOOL
as any particles left on the surface will rust and
further spoil the appearance of the finish.
NEVER USE A WIRE BRUSH, STEEL SCOURING
PADS
(EXCEPT STAINLESS), SCRAPER, FILE OR OTHER STEEL TOOLS
. Surfaces
which are marred collect dirt more rapidly and become more difficult to clean. Marring also
increases the possibility of corrosive attack. Refinishing may then be required.
Part No. 10234R3
23
2020-02-24
