Service manual for Dryer Machine
-------------------------------------------------------------------------------------------------------------------------------------------------------
-
21
-
Check all gas connections for leaks using a soap solution.
If bubbles appear, tighten the connections and recheck. DO NOT use an open flame to check
for gas leaks.
7. Using a level, check your dryer and make the necessary adjustments to the leveling legs.
8. Make sure all gas connections (Gas Models only), exhaust and electrical connections are
complete. Plug in your dryer.
9. [GAS MODELS ONLY]
The burner may not ignite initially due to air in the gas line. Allowing your dryer to operate on a
heat setting will purge the line. If the gas does not ignite within 5 minutes, turn your dryer off
and wait 5 minutes. Be sure the gas supply to your dryer has been turned on. In order to
confirm the gas ignition, check the exhaust for heat.
10. Final Installation Check
Make sure the dryer is plugged into an electrical outlet and is properly grounded.
The exhaust ductwork is hooked up and the joints are taped.
A plastic flexible duct in NOT used.
Use rigid or stiff-walled flexible metal vent material.
The dryer is leveled and is sitting firmly on the floor.
Gas models - the gas is turned on with no gas leakage.
Start your dryer to confirm that it runs, heats, and shuts off.
Door Reversal
Your dryer is built to open from left to right. You can reverse
the direction (right to left) by following steps.
1. Unplug the power cord.
2. Remove the four screws connecting the body and hinges.
Take care the door when removing and installing the screws
in case it drops and hurts you.
3. Put the door aside. Remove the screws for locker cover on the
right body and screws for the locker on the left body.
4. Install the locker onto the right body with screws. Install the
locker cover onto the left body.
5. Remove all screws around the door.
6. Disassemble the inside door board from the outside door board.
7. Turn the inside door board 180o then install it with the outside
door board.
8. Fix the screws back onto the door sides except the hinges.
9. Install the hinges onto the body left with screws.
10. Install the door onto the unit body with handles right.
Take care the hinges and screws for door and body. There are two different screws. Screws
with flat head are for hinges and door.
S c r e w s f o r
h i n g e a n d
b o d y
S c r e w s f o r
h i n g e a n d
d o o r
L o c k e r
c o v e r
L o c k e r
S c r e w
O u t s i d e
d o o r
b o a r d
I n s i d e
d o o r
b o a r d