24
INSTALLATION INSTRUCTIONS
Read these instRuctions caRefully befoRe you staRt up oR use this machine!
Warranty becomes void if the equipment is not used, set up, or maintained according to the instructions or if the machine
design is changed by third parties. The right to changes is reserved!
WaRning
·
Do not install, remove, or reinstall the AC split appliance yourself. This work must be performed be qualified technicians!
·
Incorrect installation may result in water leaks, electric shock, or fire. Please let authorised technicians perform the in-
stallation. Warranty does not apply to defects due to incorrect installation.
·
The appliance should be installed at a location with easy access. The customer is responsible for all additional costs
for special equipment.
·
Keep these operating instructions in the immediate vicinity of or on the appliance.
·
If you have any questions, please contact customer service at the phone number indicated on the back.
impoRtant instRuctions pRioR to installation
There are some basic rules to be adhered to when setting up the indoor appliance and installing the coolant lines to ensure
that the performance of the appliance is not affected:
·
Make sure the technical components of the indoor appliance technology match the outdoor appliance parts.
·
The use of third-party components will void the warranty.
·
Bring the appliance as closely as possible to the installation location in its original packaging to prevent transport dam-
ages.
·
Check the contents of the packaging for completeness and inspect the appliance for visible transport damage.
·
Report any defects to your contractual partner and the shipper immediately. Later complaints cannot be accepted.
·
Lift the indoor appliance at its corners, not at the coolant or condensation connections.
·
Select a mounting location that provides free air supply and discharge and where the appliance is not exposed to direct
sunlight or other heat sources.
·
Make sure that the air distribution is optimal and draft-free and in compliance with minimum clearances.
·
Prior to the installation, make sure that the electrical connection values comply with the data on the type plate and
perform all electrical connections according to the applicable DIN and VDE regulations.
·
Make sure that the electrical connections are properly installed on the terminals.
·
Never bend the coolant lines and do not indent them.
·
Make sure that the heat insulation for all coolant lines, including all connectors and valves, is diffusion-proof.
